ARTICLE: Ford Transit D-Pillar Trim Kit: Fit, Finishes & Install

Last updated: November 3, 2026

The GoCode D-Pillar Trim Kit is a 3-piece set for the rear doors of a 2015+ Ford Transit High Roof. It covers the rear door threshold and D-pillar transition zones, aligns to factory mounting holes with no drilling, and hides the factory black wire harness. Install takes about 1-2 hours with included hardware.

What Is a D-Pillar?

The D-pillar is the rear corner post at the back doors. On a Transit, the factory wire harness runs through this area. The kit gives you a finished surface and a place to route and conceal that harness.

What's in the Kit

  • 3-piece rear D-pillar trim kit

  • All required mounting hardware

Finish Options

  • Standard: 3/16" ABS haircell plastic

  • Matte

  • Upholstered: Marathon Tweed in Grey Heather, Black, or Toast

The trim is flanged to receive paint, upholstery, or raw ABS. For finishing help, see the paint and upholstery guides below.

Installation

Install before the wall and ceiling panels go in. It can be installed after, but you may need to trim.

  1. Clean the area and gather your hardware.

  2. Test fit the pieces against the factory holes.

  3. Paint or upholster if you're doing your own finish.

  4. Secure with the provided hardware.

  5. Check that everything is secure and lines up with the rear doors.

Care

Clean with mild detergent and water. Avoid abrasive cleaners.

Key Takeaways

  • Fits 2015+ Ford Transit High Roof and 2015+ Ford Transit Mid Roof

  • No drilling new holes. Aligns to factory holes.

  • Hides the factory black wire harness.

  • About 1-2 hours to install.

  • Standard, Matte, or Upholstered finishes.

Related Resources