INSTALL: Innie Pocket Sleeper Trim Ring for Ford Transit

Last updated: October 20, 2026

How Do I Install Innie Pocket Sleeper Trim Rings in a Ford Transit?

This guide covers installing GoCode's Innie Pocket Sleeper pair in a Ford Transit: tracing the included template off the factory inserts, cutting the wall, and dropping the sleeper pods into place for an east-west bed with no exterior flares or capsules.

Before You Start

  • Vehicle: Ford Transit

  • Kit: GoCode Ford Transit Innie Sleeper Pair

  • Mounting location: Rear side walls, driver and passenger side

  • Estimated installation time: 1-4 hrs (time dependent on wall panels)

Tools & Materials

  • Included paper template

  • Measuring tape

  • Marker or pencil

  • Vibrating (oscillating) saw (recommended for safety); a modified jigsaw blade also works

Installation Instructions

  1. Cut out your paper template. Cut the small sections along the template's line.

  2. Trace your pattern. Using the factory 8mm inserts as your reference points, trace the pattern onto your van's wall, then connect the dots with a ruler.

  3. Cut the opening. Cut away the wall, being careful not to cut too deep — a vibrating (oscillating) saw is the safer choice, though a modified jigsaw blade works too.

  4. Install the sleeper pods. Set the Innie Pocket Sleeper into the cutout on each side; you'll have sideways sleeping space instantly.

How to install a window trim ring in the innie pair?

LUKE ma dude all you boo...

Innie Pocket Sleeper Installation Video

Watch the install by AVC Rig below, or follow the written steps above.

Related Resources